<-=- Club Bevel Heaven -=->

Posted: **Sat Oct 08, 2005 9:17 pm**

I have trying to get my 750Gt running. I just purchased the bike and am having wiring problems.

Q: there is a white ceramic peice near the head stock. It is about 3 inches long and has what looks like cotton with wire around it inside.

Every time i turn on the key it starts to smoke. I can not find this part on the wiring diagram. What is it and how do I fix my smaking problem?
Please help.

Larry

Posted: **Sun Oct 09, 2005 12:56 pm**

Hi Larry
could it be that one off the previeus owners put different coils on your bike ?? K mart coils was a favorit mod with a ballast resistor
the smoking 3 inch piece you discribe could very wel be a ballast resistor
and would not show up on a wiring diagram

good luck Eldert

Posted: **Sun Oct 09, 2005 8:14 pm**

You may be right about it being a ballast resistor. The coils do not looks like any of the Ducati coils that I have on my 250cc ducatis. The bike has Dynatek eletronic ignition, but has two mis-matched car-like coils. Maybe my best bet is to get some coils from Dynatec.

Larry

Posted: **Thu Oct 13, 2005 8:34 pm**

It will smoke for a while when it is new. Just a little oil on the winding from manufacturing. Save your money. The car coils and that ballast resistor should work just fine. You can gap your plugs to at least .035". I gap mine at .038" and am using the equivalent to an NGK BP6HS.

<-=- Club Bevel Heaven -=->

750GT wiring problem

750GT wiring problem