<-=- Club Bevel Heaven -=->

Hi
I have acquired a 860gts which is not too bad but had no wiring when it came. I have built a loom but not using the original wiring diagram as the controls had been changed . All lights horn starter ignition etc work ok but now I am starting to put the body back together and the rhs side panel does not fit over the electronic ignition sender thingy. Am I missing something obvious?
Hoping someone can help me
David

If you have a Lucas Rita ignition system fitted, the trigger unit for the ignition is in the upper (rear cylinder) bevel housing.
To fit the right hand side panel requires a couple of the slots in the side panel removing.
Have a look through some of the photos on google images for 860's and you're sure to see how other people have done this modification.

Jon

Thanks, that sounds like my situation, I'll have a go
David