<-=- Club Bevel Heaven -=->

Posted: **Tue Sep 21, 2010 3:09 pm**

Can you put desmo SD heads on a valve spring GT engine?

Posted: **Tue Sep 21, 2010 5:53 pm**

Posted: **Sat Sep 25, 2010 4:18 pm**

Can you convert a GT head to SD?

Posted: **Sat Sep 25, 2010 4:49 pm**

Only if you are very proficient in the use of machine tools.
You have to bore a hole for the closing rocker spindle, very accurately.
Even then, the spacing of the inlet manifold studs would preclude fitting 40mm carbs.
In short, the answer is no, unless you have access to a well equipped workshop.

Posted: **Sun Sep 26, 2010 6:21 am**

Jon Pegler wrote:Only if you are very proficient in the use of machine tools.
You have to bore a hole for the closing rocker spindle, very accurately.
Even then, the spacing of the inlet manifold studs would preclude fitting 40mm carbs.
In short, the answer is no, unless you have access to a well equipped workshop.

Thanks.

Posted: **Tue Oct 05, 2010 10:07 am**

It's been done.

http://www.bikeexif.com/ducati-750-sport

I bet it wasn't cheap though.

<-=- Club Bevel Heaven -=->

Cylinder Head Interchange Question

Cylinder Head Interchange Question