<-=- Club Bevel Heaven -=->

I was wondering about slides in the ss1 29mm dellorto. I saw in mick walkers duc resto book (dellorto settings) that a Mach has a 60 and a 350 scrambler has a 100. I have a 350 scrambler 29mm dellorto I intend to jet as a mach 1 setup is this posssible?
The slide numbers cant be the diameter of the slide can they? The only reason I ask this is that I have 2,24 ubf carbs and the slides are different diameters.
Thanks
Jeff

Hi Jeff
the numbers of the slide corresponds with the height of the material removed on the air intake side off the slide
a small cutaway ( low number ) creates a greater vacuum and sucks up more fuel witch result in enrichment upto one quarter of throttle opening
a large cutaway ( high number ) runs leaner

Eldert