MHR voltage regulator
Posted: Thu Mar 19, 2009 1:42 am
Hello all,
I have a problem with an MHR. I can't start it anymore.
after changing the throttle cable about two months ago, I started it without problems. Two weeks ago I tried to start it but it ran only for a few turn and then cut off.
I tried to start it yesterday to take it for a ride but no luck.
The battery was a bit weak (water level very low). I added water to the
battery. The voltage is still a bit low 11.4 V at the moment.
When I try to start it I turn on the choke and it ticks over for 1 round
and then quits. After that impossible to get any life in it.
when I turn of the ignition it happens from time to time to get an
explosion in the exhaust (always left side, front cylinder)
Checking the fuel lines I wondered if the rear cylinder gets enough
fuel. The fuel line on the right side always looks empty. But when I
took of the carb and twist the trottle it is obvious that the injector
gets enough fuel so I guess that is alright.
I noticed that on the voltage regulator of the MHR there are two tabs
not connected. On the SS900 the tabs are connected to the according wires.
Does anyone know for sure if the wires on the MHR need to be connected to the regulator ? The electrics and ignition are standard.
here are two pics of MHR and SS voltage regulator.


I have a problem with an MHR. I can't start it anymore.
after changing the throttle cable about two months ago, I started it without problems. Two weeks ago I tried to start it but it ran only for a few turn and then cut off.
I tried to start it yesterday to take it for a ride but no luck.
The battery was a bit weak (water level very low). I added water to the
battery. The voltage is still a bit low 11.4 V at the moment.
When I try to start it I turn on the choke and it ticks over for 1 round
and then quits. After that impossible to get any life in it.
when I turn of the ignition it happens from time to time to get an
explosion in the exhaust (always left side, front cylinder)
Checking the fuel lines I wondered if the rear cylinder gets enough
fuel. The fuel line on the right side always looks empty. But when I
took of the carb and twist the trottle it is obvious that the injector
gets enough fuel so I guess that is alright.
I noticed that on the voltage regulator of the MHR there are two tabs
not connected. On the SS900 the tabs are connected to the according wires.
Does anyone know for sure if the wires on the MHR need to be connected to the regulator ? The electrics and ignition are standard.
here are two pics of MHR and SS voltage regulator.

