Pre Load End Float
Posted: Wed Apr 25, 2007 4:46 am
End Float
I understand that you have to “pre load” a GT750 motor by some thou to bring it in to zero end float when assembled, not sure what is the best amount, could someone help out there.
Also does anyone know if it is possible to remove “end float” from the crank by shimming between the casing and the flywheel, without have to split the cases?
Many Thanks John
I understand that you have to “pre load” a GT750 motor by some thou to bring it in to zero end float when assembled, not sure what is the best amount, could someone help out there.
Also does anyone know if it is possible to remove “end float” from the crank by shimming between the casing and the flywheel, without have to split the cases?
Many Thanks John