Hello everybody,
I'm restoring my '78 Darmah and I've run into a problem. A previous owner removed the electric start system, probably because of sprag bearing issues. I'm restoring it back to original and have been collecting all the necessary bits, or so I thought. Once I got into the engine I discovered that the washer 0799.50.188 that goes into the clutch primary gear assembly is missing. Steve doesn't have them and none of my other usual used parts sources have it either. I was hoping someone might have one that they could part with or suggest a potential source.
Thanks,
Bob
Sprag clutch washer
-
- Cucciolo - the Lil Pup
- Posts: 6
- Joined: Tue Jun 18, 2013 7:46 pm
- Location: Iowa, USA
- Craig in France
- Paso 906
- Posts: 974
- Joined: Tue Mar 23, 2004 3:58 pm
- Location: Montpellier, France
Re: Sprag clutch washer
Hi Bob,
You got a little machine shop near you? If so, might be easiest to ask them to make you up a steel washer 36 x 65.5 x 1.5 ...
You got a little machine shop near you? If so, might be easiest to ask them to make you up a steel washer 36 x 65.5 x 1.5 ...
-
- Cucciolo - the Lil Pup
- Posts: 6
- Joined: Tue Jun 18, 2013 7:46 pm
- Location: Iowa, USA
Re: Sprag clutch washer
Hi Craig,
Yes, I thought that would be my last resort. The only question would be the washer hardness but there's the washer behind the starter gear where I could get a reading.
Thanks for the note!
Yes, I thought that would be my last resort. The only question would be the washer hardness but there's the washer behind the starter gear where I could get a reading.
Thanks for the note!