Page 1 of 1

Fork stop repair

Posted: Wed Dec 21, 2016 5:40 pm
by rjk40
1975 Ducati 860GT:

One fork stop "pin" is bent from the one time I dropped the bike.

Question: any recommendations, short of welding to repair to a normal height, so the fork assembly no longer contacts the fuel tank?

Any advice is appreciated.

Thanks in advance.
Regards,
Richard Kovach
Malabar, Florida

Re: Fork stop repair

Posted: Sun Dec 25, 2016 7:19 am
by BevHevSteve
Heat it up, bend it back.

Re: Fork stop repair

Posted: Thu May 12, 2022 3:23 am
by Chasbmw
On a 750 GT should there be any “ Bumpers” on the fork stops? Mine has a some made up of fuel tubing, bike is apart at the moment so can’t see if they are required to protect the tank?