1974 750 GT with PHF32 jetting recommendation

Post your 'Carburettor & Fuel System' FAQs, comments & questions regarding Ducati motorcycles here.
Post Reply
gt94stang
Cucciolo - the Lil Pup
Posts: 16
Joined: Fri Dec 28, 2018 4:53 am

1974 750 GT with PHF32 jetting recommendation

Post by gt94stang »

Hey Guys,

Still working on my GT. I have been chasing a hanging rpm problem for quite awhile now. Replaced the exhaust gaskets, replaced the intake insulators with the new aluminum ones with o-rings from Steve. No stuck cables or slides or anything. This bike has PHF32 instead of the stock PHF30 carbs and it has K&N Pod filters and Conti knockoff mufflers. I'm sure this is not an uncommon setup and I think my problem is that the carbs are just setup to lean. What would be the recommended jetting for this setup and float height?

Thanks,
Rob
User avatar
geodoc
750 GT
Posts: 182
Joined: Thu Jul 18, 2013 3:57 pm
Location: Vancouver BC Canada

Re: 1974 750 GT with PHF32 jetting recommendation

Post by geodoc »

Here's what I finally ended up using in my '73 GT using PHF32's & Wiseco 'Sport' C.R. pistons after much fiddling and fussing on the dyno and then seat of the pants for final tweaks.

MJ 125
NJ: 265AB
PJ: 62
Needle: K16 (bottom / richest notch)
Slide: 70/2

~ Sea level, Chevron 94 non-ethanol, pod filters, Contis.

Float level setting here (page 10):

www.thisoldtractor.com/mg_manuals/dello ... de_1.1.pdf






.
Post Reply

Return to “Carburettor & Fuel System Shop”