<-=- Club Bevel Heaven -=->

Sorry for the delay, been traveling. Got it back together today. Third crank fired right up! I think I need to rebuild the carb now. The idle mixture screw on the left side does nothing. Thanks for the advice!

Do you know what the tolerance is on the shafts?

Good call wdietz186, it's an SKF part. I was able to find a replacement for it locally!

I was wondering if I need the gasket between the cases or if I can just use silicone gasket maker? Will it affect the clearance on the Crankshaft?

I don't think so. It looks like a sleeve that goes over the shaft, between the roller bearings in the case and the shaft. Almost like a protection device to save the shaft if the roller bearings fail. That is good idea though, I'll take some measurements and check out some Industrial bearing supply ...

I'm putting a 1987 750 Paso back together and need the bearing race/sleeve that goes over the right side of the transmission output shaft. It goes between the shaft and the roller bearing on the right side. The bike was disassembled before I got it so this is my last piece prior to reassembly. Any ...

Hello from Kansas! Co-owner of a 1987 750 paso that needs a little TLC. Currently reassembling after a chain failure caused the motor case to break. Hope to have it done by December but need help with a few small parts.