<-=- Club Bevel Heaven -=->

Does anyone know of a supplier of Fork Screws (that's the top fork nuts that have a hex in them) to suit Marzocchi 35mm disc brake type forks used on many Italian motorcycles?

Hey TD,
I have a 12mm Nissin master cylinder mated to a single F08 caliper and stainless braided line with the same results.
Little travel but great brakes.
Sorry, can't answer whether or not the 11mm master would help.
Dean[/quote]

Hi Dean

Thanks for your reply and now I know that what I have ...

I have a Brembo 12mm master cylinder with single F08 caliper and noticed that when I finally managed to fully bleed the system the lever movement / travel once the brake pads have been pumped onto the disc is minimal. Is this normal for this combination?

Would a 11 mm master cylinder produce a ...

Ikon in Australia made me a spring compressor to remove the old Koni and their new Ikon springs.

I was wondering what the runout limits are for a solidly mounted disc with Brembo 08 calipers?

I currently have measured near the outside edge of the disc of 0.08 mm (0.0031") runout.

Italian Fork Identification

I have purchased a pair of 35 mm Italian forks that I wish to use on my historic racer and I have created a web page to show the full details of the forks that I need identified at:

http://www.htb.com.au/htb27.html

I need to know what bike they came from?

Year of ...

Brembo Caliper Change

I have a pair of forks, which have a single caliper mounting spacing of 94 mm's and use 8 mm x 1.25 mm pitch retaining bolts.

I suspect that the Brembo F05 twin piston caliper would have been used but ideally I would like to use a replacement Brembo F08 caliper on the rear ...