Cylinder barrel - identification markings

If you need technical information or help with your BOSCH ignition squarecase Ducati 900SS - Darmah engine - post your FAQs, comments & questions here.
Post Reply
PJDucati
Cucciolo - the Lil Pup
Posts: 7
Joined: Tue Nov 19, 2013 4:46 am

Cylinder barrel - identification markings

Post by PJDucati »

Hi. This is a long shot and I realise I am unlikely to get an explanation, but here goes....

I have removed the barrels of my 1982 MHR and they have both been bored to 88mm. (cast iron liner). On the top face of the aluminium near the liner are some initials or markings of someone I assume has previously worked on the engine. Both barrels have 'Bs' stamped on the aluminium. ( capital 'B' lower case 's'.) I wondered if this was for a specific rider or whether the engine builder has 'signed' his work. ( This is not uncommon on clock makers/repairers).

Any suggestions anyone?
Thanks,
Phil.
Post Reply

Return to “Squarecase BOSCH Ignition Engines > SD, SSD Darmah, late 900 SS & 900 GTS”