S2 Wiring neutral wires

If you need technical information or help with your BOSCH ignition squarecase Ducati 900SS - Darmah engine - post your FAQs, comments & questions here.
Post Reply
[email protected]
Cucciolo - the Lil Pup
Posts: 3
Joined: Sat Oct 24, 2009 7:58 pm

S2 Wiring neutral wires

Post by [email protected] »

Just wondering if any one can help, Im building a 84' S2 from scratch and getting to the wiring part, Q. I have (as shown in the wiring diagram) a couple of "blue-black" wires with bullet type connectors leaving the loom about 1/2 way down, I asume they are connected to the neutral switch, but where? I cant see any other wires from the engine other than the alt and ignition :? Tom
Tom
Per Garbos
Diana
Posts: 55
Joined: Sat Feb 03, 2007 11:41 am
Location: Denmark

Post by Per Garbos »

at my S2 from 83 the neutral switch is sitting outside just behind the sprocket.
In same area here should be an excentric from the gearbox activating the switch.

The switch is located in a approx. Ø12- 15 mm hole in engine case and is held with a M6 screw.

Hope this can help.

Best regards Per
[email protected]
Cucciolo - the Lil Pup
Posts: 3
Joined: Sat Oct 24, 2009 7:58 pm

Post by [email protected] »

bloody italians, thanks :)
Tom
Post Reply

Return to “Squarecase BOSCH Ignition Engines > SD, SSD Darmah, late 900 SS & 900 GTS”