Compliance Plate removal question

If you need technical information or help with your BOSCH ignition squarecase Ducati 900SS - Darmah engine - post your FAQs, comments & questions here.
Post Reply
MartinMille BANNED
BANNED
Posts: 766
Joined: Fri Sep 21, 2007 8:15 pm

Compliance Plate removal question

Post by MartinMille BANNED »

Hi All

Getting the frame ready for power coating but how does one remove the tiny
Compliance Plate rivets and can you still get them?
User avatar
BevHevSteve
SITE OWNER
SITE OWNER
Posts: 2324
Joined: Wed Mar 10, 2004 8:53 pm
Location: Lafayette, California
Contact:

Post by BevHevSteve »

use a small punch from the inside of the frame, or, center punch the head of the rivet, carefully drill off the head then use the punch on the outside to drive it out. I stock replacement rivets
Image
Steve Allen (925)798-BEVL[2385] Ride'm, Don't Hide'm
Ducati/Euro Spares -> https://Store.BevelHeaven.com
MartinMille BANNED
BANNED
Posts: 766
Joined: Fri Sep 21, 2007 8:15 pm

Post by MartinMille BANNED »

Hi Steve

These are the once where in your store are they

also could you send me some pictures of the rear side of your chrome Bar End Mirrors and where are they made?

Image
User avatar
BevHevSteve
SITE OWNER
SITE OWNER
Posts: 2324
Joined: Wed Mar 10, 2004 8:53 pm
Location: Lafayette, California
Contact:

Post by BevHevSteve »

i don;t have any chrome bar end mirrors, only the machined aluminum CRG and the stainless steel halcyons
Image
Steve Allen (925)798-BEVL[2385] Ride'm, Don't Hide'm
Ducati/Euro Spares -> https://Store.BevelHeaven.com
Post Reply

Return to “Squarecase BOSCH Ignition Engines > SD, SSD Darmah, late 900 SS & 900 GTS”