<-=- Club Bevel Heaven -=->

Hi Folks,

I want to remove the grease nipple from my 750 GT swing arm before sending off to the powder coater. This maybe easy for some but for me, I'm challenged... It's base is round (can't use an open ender) and using multigrips, lightly, I'm afraid of damaging the nipple. Is there a secret to removing it, or should I just squeeze harder on the nipple to remove it...thx

Best thing to do is just put a pair of grips on it and pull it out! It is a puch fit in the arm.

When you get it back from the powder coaters, drill and tap it to take a new grease nipple that way there wont be any grit in the nipple.