Question about 750 rear cylinder head

Post your general FAQs, comments & questions regarding all Ducati engine & transmission restoration here. [Specific engine FAQs should go in the 'BevelHeaven Garage' section.]
Post Reply
photomd
Cucciolo - the Lil Pup
Posts: 1
Joined: Fri Jan 08, 2016 3:40 pm
Location: The Land of Cotton (South Carolina)

Question about 750 rear cylinder head

Post by photomd » Sun Feb 14, 2016 8:45 am

Hello...I have a problem. I have a 74 750GT that I bought in November. As I was going throught the bike, it became obvious that it needs a rebuild. So, with the help of a friend, we are getting the bottom end together, but the heads required some work. The front head looks pretty straight forward, but the rear head has a crack along the exhaust port. The head shop is unsure they can weld it and get the exhausts seat re-installed properly. So I'm in the market for a new rear head. Does anyone know if an 860 head will work? Anyone have a source for a round case 750 head? Thanks for any help y'all can provide.

Post Reply

Return to “Engine & Transmission Shop”