Sprag Bearing Outer Race
Posted: Sat Apr 04, 2015 1:19 am
Hi folks
I am replacing the sprag bearing outer race on my 78 Darmah. This is the one held in with 6 screws and located on two pins. How does this come out? Do I need a gear puller or do I press out the internal taper and then push the race out using a hydraulic press?
I am replacing the sprag bearing with later model upgrade kit. I note that one of the things I will likely have to do is then adjust the backlash between the clutch basket and the primary pinion.
How is this backlash measured and where should I be adjusting this?
Thanks for your help,
Elliot
I am replacing the sprag bearing outer race on my 78 Darmah. This is the one held in with 6 screws and located on two pins. How does this come out? Do I need a gear puller or do I press out the internal taper and then push the race out using a hydraulic press?
I am replacing the sprag bearing with later model upgrade kit. I note that one of the things I will likely have to do is then adjust the backlash between the clutch basket and the primary pinion.
How is this backlash measured and where should I be adjusting this?
Thanks for your help,
Elliot