<-=- Club Bevel Heaven -=->

Posted: **Thu Nov 15, 2012 3:58 pm**

Here are some photos and a spec drawing of that funky little coupler piece inside your tach drive in case you need to make one...

Posted: **Fri Nov 16, 2012 12:57 am**

Ah - that's the little piece that likes to fall out and roll under the bench, yes? >:|!!!

Thanks Steve. Could be useful, hope it never is ...

Ciao

Craig

Posted: **Fri Nov 16, 2012 6:13 am**

Yes Craig, I bet you can figure out why I needed to make measurements of one then.... So I thought, since I had the info, I might as well post it.

Posted: **Fri Nov 16, 2012 9:37 am**

BevHevSteve wrote: So I thought, since I had the info, I might as well post it.

Ah, 'The Power of the Web', eh Steve? Good, init?

Posted: **Sat Nov 17, 2012 8:52 am**

Might want to do the same with the Oldham coupler for the shifter box too! They seem to disappear when things are apart for a while.

Posted: **Mon Nov 19, 2012 4:07 pm**

Amen to both bits!!! Amazing what nooks and crannies they can disappear, or rather, fit into!
Regards,

Tach drive coupling piece detail