Tach drive coupling piece detail

Post your general FAQs, comments & questions regarding all Ducati engine & transmission restoration here. [Specific engine FAQs should go in the 'BevelHeaven Garage' section.]
Post Reply
User avatar
BevHevSteve
SITE OWNER
SITE OWNER
Posts: 2124
Joined: Wed Mar 10, 2004 8:53 pm
Location: Lafayette, California
Contact:

Tach drive coupling piece detail

Post by BevHevSteve » Thu Nov 15, 2012 3:58 pm

coupler.jpg
DSCN2991.jpg
DSCN2990.jpg
Here are some photos and a spec drawing of that funky little coupler piece inside your tach drive in case you need to make one...
Image
Steve Allen (925)798-BEVL[2385] Ride'm, Don't Hide'm
Ducati/Euro Spares -> https://Store.BevelHeaven.com
Facebook > http://facebook.com/Bevel.Heaven
Twitter > http://www.Twitter.com/BevelHeaven

User avatar
Craig in France
Cagiva Elefant
Posts: 820
Joined: Tue Mar 23, 2004 3:58 pm
Location: Montpellier, France

Re: Tach drive coupling piece detail

Post by Craig in France » Fri Nov 16, 2012 12:57 am

Ah - that's the little piece that likes to fall out and roll under the bench, yes? >:|!!! :doh:

Thanks Steve. Could be useful, hope it never is ... :)

Ciao

Craig

User avatar
BevHevSteve
SITE OWNER
SITE OWNER
Posts: 2124
Joined: Wed Mar 10, 2004 8:53 pm
Location: Lafayette, California
Contact:

Re: Tach drive coupling piece detail

Post by BevHevSteve » Fri Nov 16, 2012 6:13 am

Yes Craig, I bet you can figure out why I needed to make measurements of one then.... So I thought, since I had the info, I might as well post it.
Image
Steve Allen (925)798-BEVL[2385] Ride'm, Don't Hide'm
Ducati/Euro Spares -> https://Store.BevelHeaven.com
Facebook > http://facebook.com/Bevel.Heaven
Twitter > http://www.Twitter.com/BevelHeaven

User avatar
Craig in France
Cagiva Elefant
Posts: 820
Joined: Tue Mar 23, 2004 3:58 pm
Location: Montpellier, France

Re: Tach drive coupling piece detail

Post by Craig in France » Fri Nov 16, 2012 9:37 am

BevHevSteve wrote: So I thought, since I had the info, I might as well post it.
Ah, 'The Power of the Web', eh Steve? Good, init? :-D

wdietz186
888
Posts: 672
Joined: Sun Sep 10, 2006 4:40 pm

Re: Tach drive coupling piece detail

Post by wdietz186 » Sat Nov 17, 2012 8:52 am

Might want to do the same with the Oldham coupler for the shifter box too! They seem to disappear when things are apart for a while.

radecal
Parallel Twin
Posts: 102
Joined: Thu May 18, 2006 6:40 am
Location: Australia

Re: Tach drive coupling piece detail

Post by radecal » Mon Nov 19, 2012 4:07 pm

Amen to both bits!!! Amazing what nooks and crannies they can disappear, or rather, fit into!
Regards,
RAD

Post Reply

Return to “Engine & Transmission Shop”