Big end bearings s/n

Post your general FAQs, comments & questions regarding all Ducati engine & transmission restoration here. [Specific engine FAQs should go in the 'BevelHeaven Garage' section.]
Post Reply
hashashan
Mach 3
Posts: 88
Joined: Wed Oct 07, 2009 11:42 am

Big end bearings s/n

Post by hashashan » Mon Feb 21, 2011 1:44 am

Hello,
does anyone know the serial number of the big end bearings of a 78 darmah ?

ducadini
860 GT / GTS
Posts: 250
Joined: Sat Jul 31, 2004 9:54 am
Location: Antwerpen

Post by ducadini » Mon Feb 21, 2011 8:45 am

I don't think they are available separately. Come with the bigend-set.
The rollers are standard items, but I think the cage is special.
cu
ducadini
Nego i ricordi peggiori
Richiamo i migliori pensieri

hashashan
Mach 3
Posts: 88
Joined: Wed Oct 07, 2009 11:42 am

Post by hashashan » Mon Feb 21, 2011 9:08 am

ahh no problems with that. i just want to see how much they cost here. so i need the serial number of the bearings .. rollers+cage. I just couldn't fins this anywhere.

http://cgi.ebay.com/ducati-bevel-twin-7 ... 500wt_1156

this price makes any sense? 400$ for bearings?

wdietz186
Cagiva Alazzura
Posts: 703
Joined: Sun Sep 10, 2006 5:40 pm

Post by wdietz186 » Mon Feb 21, 2011 7:02 pm

The problem you will run into is if the bearings are worn,the crankpin will be too, along with the ID of the rods that is why the parts are supplied as a set. The rollers themselves don't usually wear much it's the pin and rods that wear because they are the softer pieces.

ducadini
860 GT / GTS
Posts: 250
Joined: Sat Jul 31, 2004 9:54 am
Location: Antwerpen

Post by ducadini » Thu Feb 24, 2011 11:37 pm

As the seller says : IF the rods aren't damaged, you can use this set.
Don't know about the diameters though : this set is the stepped 36-38.
Some Darmahs had 36 but others had 38 mm.
cu
ducadini
Nego i ricordi peggiori
Richiamo i migliori pensieri

Post Reply

Return to “Engine & Transmission Shop”