Oil Leak

Post your general FAQs, comments & questions regarding all Ducati engine & transmission restoration here. [Specific engine FAQs should go in the 'BevelHeaven Garage' section.]
Post Reply
Brian Lees
Cucciolo - the Lil Pup
Posts: 16
Joined: Thu Mar 18, 2004 8:40 pm
Location: Campbell River BC

Oil Leak

Post by Brian Lees » Wed Aug 04, 2004 9:34 pm

My new aquisition 80 Darmah SS seems to have developed an oil leak in the countershaft area. no doubt from sitting in a barn for the last 10 years. any hints would be greatfully appraciated. I sure hope in not going to have to go inside to put in a new seal.

thanx

User avatar
BevHevSteve
SITE OWNER
SITE OWNER
Posts: 2188
Joined: Wed Mar 10, 2004 8:53 pm
Location: Lafayette, California
Contact:

ducati automatic chain oiler

Post by BevHevSteve » Sun Aug 29, 2004 11:32 am

easy fix, done outside the motor. 2 different seals, 1 small one just inside the countershaft sprocket in the tube, you can stuff in 2 or 3, the larger one on the outside of the shaft is harder to replace but not too difficult, usually it is the samll one[s]...... I stock both. Clean everything up real well, go for a ride, then look to see where exactly it is leaking from then get back to me to buy the seals.
Image
Steve Allen (925)798-BEVL[2385] Ride'm, Don't Hide'm
Ducati/Euro Spares -> https://Store.BevelHeaven.com
Facebook > http://facebook.com/Bevel.Heaven
Twitter > http://www.Twitter.com/BevelHeaven

User avatar
Craig in France
Cagiva Gran Canyon
Posts: 875
Joined: Tue Mar 23, 2004 3:58 pm
Location: Montpellier, France

Oil leak

Post by Craig in France » Mon Sep 27, 2004 3:49 pm

And don't forget the Steve Wynne tip - use two nuts and put some silicone on the threads. Working for me ... :-D

duck-a-tye
Mariana
Posts: 42
Joined: Fri May 28, 2004 2:52 am
Location: Australia

Post by duck-a-tye » Tue May 17, 2005 4:03 am

Hi Craig, are you talking about fitting two sprocket nuts? and silicone instead of loctite on the threads?

Cheers

User avatar
Craig in France
Cagiva Gran Canyon
Posts: 875
Joined: Tue Mar 23, 2004 3:58 pm
Location: Montpellier, France

Post by Craig in France » Tue May 24, 2005 4:01 pm

Hi duck-a-tye

Yup, that's it. 2 of the round sprocket nuts, silicone on the threads ...

"If it's good enough for Steve, it's good enuf for me :)"

Craig in UK

duck-a-tye
Mariana
Posts: 42
Joined: Fri May 28, 2004 2:52 am
Location: Australia

Post by duck-a-tye » Mon May 30, 2005 3:42 am

Thanks Craig,

How's the weather in the UK? must be nearly good enough for riding soon!

Post Reply

Return to “Engine & Transmission Shop”