Page 1 of 1
Camshaft regrinding
Posted: Wed Jul 07, 2004 10:57 am
by Norman Castaneda
During engine component inspection, while performing an overhaul, I've discovered pitts in both of the camshafts of of my '74, 750GT. Can anyone recommend a competent machine shop to regrind these parts for me, or is it customary to replace these expensive parts and discard the defective ones? My estimate of the depth of the pits may be in the order .005" inch or so, and they do not appear on the "critical" parts of the lobes. How deep is the hard face treatment of these cams?
Thanks,
Norman Castaneda
its the pits
Posted: Thu Mar 03, 2005 1:29 pm
by BevHevSteve
contact MEGA CYCLE to ask them what to do. They do regind and resurface treatment as well as sell replacment cams etc
Re: its the pits
Posted: Wed Mar 09, 2005 7:58 pm
by DesmoDog
BevHevSteve wrote:contact MEGA CYCLE to ask them what to do. They do regrind and resurface treatment as well as sell replacement cams etc
Not anymore. At least that's what I was told today when I called to ask. They do still replate rockers though.
grinding
Posted: Wed Mar 09, 2005 8:56 pm
by BevHevSteve
oh bummer - they used to do all this kind of good work..... They did my rockers and cams on my racebikes through the years.