How to place the plastic seal in the sleve gear ?

Per Garbos · Post by **Per Garbos** » Wed Jun 27, 2007 12:14 am

I am rebuilding my gearbox and have a problem

There is a double lipped plastic seal witch fits inside the end of the sleve gear.
But how to place it .. with the open side outwards or with the open side into the sleve gear?

Regards Per

lozz900 · Post by **lozz900** » Fri Jul 20, 2007 2:47 am

Mine had the open side facing inwards and i believe it was fitted correct.

Per Garbos · Post by **Per Garbos** » Sun Jul 22, 2007 12:16 pm

You are rigth about that.

The problem was that the seal from the factory was fittet with the open side outwards, and then I was no longer sure.

But now it is placed correct as You describe it.

Thanks a lot.

Per