Tap and die set
Posted: Tue May 26, 2015 8:33 am
Hey folks,
Can anyone make a recommendation on a tap and die set that would cover all the 1.0mm pitch (extra fine) threads on the old singles? If it helps, my model is a 66 Ducati Monza. I was thinking of picking up either of the follow but don't know if that's enough 1.0mm pitch to cover all the threads. I'm getting all my parts back from the powder coater this week and I'll need to chase all the threads. Not just from powder coat but just being generally cruddy from the years.
http://www.amazon.com/Irwin-Industrial- ... DFKSMTM4NS
or
http://www.amazon.com/Neiko-45-Piece-Hi ... ap+and+die
Thanks!
Can anyone make a recommendation on a tap and die set that would cover all the 1.0mm pitch (extra fine) threads on the old singles? If it helps, my model is a 66 Ducati Monza. I was thinking of picking up either of the follow but don't know if that's enough 1.0mm pitch to cover all the threads. I'm getting all my parts back from the powder coater this week and I'll need to chase all the threads. Not just from powder coat but just being generally cruddy from the years.
http://www.amazon.com/Irwin-Industrial- ... DFKSMTM4NS
or
http://www.amazon.com/Neiko-45-Piece-Hi ... ap+and+die
Thanks!