Request help in selecting carb for 350 engine, dirt bike
Posted: Sat Feb 26, 2005 8:40 am
I'm building a dirt bound 350. Intake port is 26mm, I'd like to blend this out to 28/30mm and fit a Mikuni. Welcome input on the porting.
Most Mikuni's are jetted for two strokes. Can anyone recommend a source for Mikuni carbs set up at least in the ball park for a 350? Or offer up slide and jetting advice so I can convert an ebay carb? Or..., is there another carb I might consider?
This bike might see a low key club race or two, but is going to be setup as street legal DP in a Maico chassis ( a Maicati! ), and longevity is more important than max performance. But I would like to boost output a bit with a larger carb. Heck, a Honda XR200 runs a 26mm, I ought to be able to run something bigger on a 350...
Thanks,
Jon
Most Mikuni's are jetted for two strokes. Can anyone recommend a source for Mikuni carbs set up at least in the ball park for a 350? Or offer up slide and jetting advice so I can convert an ebay carb? Or..., is there another carb I might consider?
This bike might see a low key club race or two, but is going to be setup as street legal DP in a Maico chassis ( a Maicati! ), and longevity is more important than max performance. But I would like to boost output a bit with a larger carb. Heck, a Honda XR200 runs a 26mm, I ought to be able to run something bigger on a 350...
Thanks,
Jon