F1A hydraulic clutch

If you need technical information or help with your pantah based twin Ducati F1, F3, TT1, TT2, Santamontica, Montjuich, Laguna Seca, Al'azzurra, Pantah XL/TL etc engine - post your FAQs, comments & questions here.
Post Reply
hms86f1
Cucciolo - the Lil Pup
Posts: 6
Joined: Sat Aug 29, 2020 3:45 am

F1A hydraulic clutch

Post by hms86f1 »

I need to remove the clutch slave cylinder piston and bearing inside the clutch cover.

Don't have the tools so I'll take it to a shop, but there are no Ducati shops within 200 miles of here.

I presume the bearing is first pulled out with a small (8mm) puller. True?

Does this require heat to be applied?

Any insights will be greatly appreciated.
hms86f1
Cucciolo - the Lil Pup
Posts: 6
Joined: Sat Aug 29, 2020 3:45 am

Re: F1A hydraulic clutch

Post by hms86f1 »

Thanks Mr. Allen, for the tip about the grease gun, I'll give it a try!
Post Reply

Return to “'Straight Head' Pantah Engines [rear exhaust faces forward] > F1, F3, Pantah, TL, XL, TT1, TT2, Al'Azzurra”