Clutch Slave Cylinder O-Ring

If you need technical information or help with your pantah based twin Ducati F1, F3, TT1, TT2, Santamontica, Montjuich, Laguna Seca, Al'azzurra, Pantah XL/TL etc engine - post your FAQs, comments & questions here.
Post Reply
mmmexico
Cucciolo - the Lil Pup
Posts: 2
Joined: Tue Mar 27, 2012 3:25 pm

Clutch Slave Cylinder O-Ring

Post by mmmexico » Tue Mar 27, 2012 3:30 pm

So...Here's the problem. It seems that I have an early F1 and the seal on the slave cylinder of the clutch is in the bore of the slave cylinder. My slave cylinder is 31mm in diameter, so the O-Ring is going to have to be somewhat larger. Does anyone know of a quick and easy place/person/business from whom I can buy a couple???


In advance...Thanks!!!


Mike

radecal
Parallel Twin
Posts: 102
Joined: Thu May 18, 2006 6:40 am
Location: Australia

Re: Clutch Slave Cylinder O-Ring

Post by radecal » Tue Apr 03, 2012 2:51 am

G'day Mike,
This was a topic on the Pantahead List recently and a special seal is available to replace the original one.
I can check to see if I still have the post. I have an '86 F1 so was also after the seal for mine as I seem to remember they had a couple of sizes.
Regards,
RAD

Post Reply

Return to “'Straight Head' Pantah Engines [rear exhaust faces forward] > F1, F3, Pantah, TL, XL, TT1, TT2, Al'Azzurra”