Page 1 of 1
Posted: Mon Mar 29, 2004 12:31 pm
having just rebuilt the cylinder head and refitted it,and after retiming the valves by means of the timing marks, i find that the ignition timing is 180 degrees out!
how can i remedy this without taking the head off again?
Posted: Sat Apr 03, 2004 7:08 pm
What would happen if you unpluged the ignition wires coming out of the points housing, and switch them around?
Posted: Sun Apr 04, 2004 10:28 am
unfortunately the ignition cam has only one lobe and this is now 180 degrees out,also the points back plate is not reversible, thanks for trying,L A
Posted: Fri Apr 09, 2004 5:07 pm
Posted: Wed Apr 14, 2004 12:05 pm
What I mean is to unplug the wires at the connector and then plug each wire into the other wire's receptacle. I made the same mistake and had to do it to mine too.