Closing rocker holding tool for parrallel twin
Posted: Fri Dec 05, 2008 3:15 am
Guys,
I have just made a closing rocker holding tool for a desmo parrallel twin. It is a slight variation on a bevel v-twin one, but definately does the job.
Now would anyone else like one? I am thinking of getting a small batch made up, cost would be about GBP39.00 each + post and packing.
If interested e-mail [email protected].
I have a photo that I can e-mail back
I have just made a closing rocker holding tool for a desmo parrallel twin. It is a slight variation on a bevel v-twin one, but definately does the job.
Now would anyone else like one? I am thinking of getting a small batch made up, cost would be about GBP39.00 each + post and packing.
If interested e-mail [email protected].
I have a photo that I can e-mail back