Bearings.
Posted: Thu Dec 11, 2008 10:50 pm
Hi Steve,
hope I'm not posting this in da wrong place but here goes!
I was reading some old Bevel forum stuff to see if I could pick up some tips and came across a posting re wheel brgs,now I have an '88 rubber band thingy that has exceptionally stuborn front wheel brgs.
Now I certainly don't wish to snap out a section of rim casting trying to remove brgs, I noticed the link to the shop in regards the "Bearing Remover"and had a looky see; will this be the answer to my prob?
Any advice appreciated.
Thanks mate, and great site. Chris.
hope I'm not posting this in da wrong place but here goes!
I was reading some old Bevel forum stuff to see if I could pick up some tips and came across a posting re wheel brgs,now I have an '88 rubber band thingy that has exceptionally stuborn front wheel brgs.
Now I certainly don't wish to snap out a section of rim casting trying to remove brgs, I noticed the link to the shop in regards the "Bearing Remover"and had a looky see; will this be the answer to my prob?
Any advice appreciated.
Thanks mate, and great site. Chris.