<-=- Club Bevel Heaven -=->

I am in dire need of a tool tray to fit my 74GT
the one I bought will not accept the bracket to hold my fuse box and
regolator.

any body know where I can get even a used one

thanks,

Gerard

Hi ... I may be able to help you. But I need to know which one you just got that won't work.
Can you post a picture of the one that won't work?
Or just email a picture to me?

..........Den.....

..... [email protected]
.
.

FWIW Den helped me out with one for my '74...


Not the greatest pic but you can see the bracket for the fuses/regulator fits fine.



The fuse box and regulator aren't stock, but the bracket is...

Craig

Den is making a tool tray for me like the one you have.
It will accept the bracket that holds the reg and fuse box.
I sent him a pict of the earlier one I bought which wont accept the
metal bracket.
thanks for the pict.
Didyou repack or remove your rear wheel brgs ???
how did you get them out ????

The tray should work great.

I'm pretty sure I changed the rear wheel bearings since I changed 95% of the bearings in the bike, but I can't remember how I removed the old ones... It's been five or six years since I did it...

Craig

I got the brgs out
I am going to replace them all with sealed SKF`s
Got my new tool tray on sat, fit just fine. Den did a great job

Gerard