<-=- Club Bevel Heaven -=->

Posted: **Wed Sep 16, 2009 12:38 pm**

This is my project bike, it's replica of the factory TT1 used during -84 up to -86. I've been bulding on it since 2004 and it was completed and tested in -06. The bike has been under constant development.

Engine - Paso -88, ported F1 heads, valves 44/35. Crower conrods. Montjuich cams, Carb. Malossi 41,5.
Frame - Built by Morani in Sweden, Marzocchi 42,7 fork.

http://picasaweb.google.com/DucatiTT1re ... 1596485266

Ulf

* Admin note: I added a couple of your photos so you could see how it is done, I hope you do not mind Ulf.....

Posted: **Wed Sep 16, 2009 4:02 pm**

Good work Ulfand! Who did the fuel tank?
Ian

Posted: **Thu Sep 17, 2009 12:30 pm**

Macdesmo wrote:Good work Ulfand! Who did the fuel tank?
Ian

Hi!
Thanks, It was Peter at Morani in Sweden, he made the frame as well.
//Ulf

Posted: **Wed Sep 30, 2009 9:07 am**

Pretty motorcycle..
I am with a similar project with my TT1 Replica...I hope to enjoy it soon!!!

Your front wheel is of 16"????

Posted: **Wed Sep 30, 2009 10:42 am**

Pantah wrote:Pretty motorcycle..
I am with a similar project with my TT1 Replica...I hope to enjoy it soon!!!

Your front wheel is of 16"????

Hi!
No I'm running 17 inch front and rear. It's easier to find tyres.

Regards Ulf

Posted: **Wed Sep 30, 2009 1:30 pm**

ulfand wrote:
Pantah wrote:Pretty motorcycle..
I am with a similar project with my TT1 Replica...I hope to enjoy it soon!!!

Your front wheel is of 16"????
Hi!
No I'm running 17 inch front and rear. It's easier to find tyres.

Regards Ulf

I have marvic of 16"...I hope to find some tire!

<-=- Club Bevel Heaven -=->

Ducati TT1 Replica

Ducati TT1 Replica