<-=- Club Bevel Heaven -=->

The enameled wire looks ok (newly rewound) it's the rubber covered wire that passes through the oil and out through the gland, that is cactus. It seems incredible that the hard part of the job is done and then they simply re-attach the old part back onto the newly rewound part.... When I asked WTF? ...

So I am not the only one who gets unsatisfactory service there. I am going to attempt the repair myself. In the event of a failure I have had good results from he small coil rewinds and I will use them for sure. Thanks for the reply. Cheers James [/b] Good luck James, think I know where you've been ...

BevHevSteve wrote:Thanks for updating your email to correctly now reflect [email protected]

Sorry for the hassle,
Cheers James

PM sent

Lumpy wrote:I may have an 860 head if your interested. I am in Australia also. PM me if your still looking for one. Mean time I`ll have a dig around in the shed and see if I can find it.

The one from my GTS is well cracked, the whole motor looks like it got real hot at least once. The crack is in a position that renders it a [ desperation only] reweld repair. Thanks to Ray for his email Still looking for Bill to answer the PM I sent Still looking at this stage....... Funny thing th...

Hello I am having trouble with sourcing a rear head for my GTS 860 project. I got ripped off already[OK if I looked harder and asked more questions prior to paying...]. Prefer one not cracked but willing to look at what you can offer. I am in Australia.
Pm me please -or email [email protected]

I purchased a re-manufactured/upgraded alternator for my 1977 GTS from NSW- Australia-, the vendor has had the alternator rewound ,but re- used the original wire harness. The wires are too short and the internal insulation is heat damaged[ useless] the vendor is uncooperative, so I must re wire the ...

wdietz186 wrote:Yes.

Thankyou..

Is it correct to fit stem seals to both inlet and exhaust please??

I want to buy a L/H sidecover for my 1977 GTS I want one with no electric start [off an SS] ......or swap my old L/H cover + the electric start assembly complete- for your one without. OR swap for my later model L/H sidecover with no starter[off an SS or similar]. Cash is a last option Turns out th...

muchas gracias

Will Darmah header pipes fit and work OK on my 1977 GTS resto??
please.
James

Ok so I am up to mains on my rebuild project. I have numbers on my 9removed]bearings as follows RHP7307x2 TB RR The bearing shop has 7307X2 in either brass or plastic cage -40 Degree annular-11 balls-[in stock ready to go] or They have a listing for RHP B7307 sold as a pair[ they have no stock and w...

I figure the best action is to bolt the barrel up to the crankcase and remeasure. I will need to make up a ring to act in place of the head and see what happens

hello I have a problem with the re-boring of my 860 GTS; the machinist has used a torque plate process, and is unsure if he has got it right. Apparently the cylinder is clamped into the borer and tensioned to mimic in service condition. In this shop the cylinder was clamped to a purpose modified fly...