<-=- Club Bevel Heaven -=->

congratulations on getting this thing back together! API or JASO ratings matter to get the high zinc content needed.

API "SG" rated
JASO MA or MA2 rated

I like MOTUL 3000 20w50 dino oil, no need to pay the extra for semi syn.................

::::-=-::: NEW :::-=-:::: if you start a new topic or reply to someone and wish to easily post a photo or 3, look at the bottom box for a tab that says UPLOAD ATTACHMENTS. Click it then click BROWSE which will allow you to find the photo you wish to upload onto the forum. Click the image file you wa...

too low - check valve lash to start, then timing, carb sync etc

FYI - these are both DD carbs - the adjusters are on the right side of BOTH carbs. The manifolds are for a PASO or MONSTER etc where the original carb setup was both carbs between the cylinders. Using 2x RIGHT SIDE carbs mean once installed the adjusters are towards the outside of the bike on each s...

welcome aboard,

Have a look at my store - https://Store.BevelHeaven.com once you are ready to start grabbing your rebuild bits and pieces.

welcome aboard

good find there - welcome aboard.

- part # 0805.16.820

if its the factory MC then it is in fact the same bore as the front and uses the same kit. Yes there are identical units out there that are 12mm found on some PANTAH bikes.

if its the factory MC then it is in fact the same bore as the front and uses the same kit. Yes there are identical units out there that are 12mm found on some PANTAH bikes.

Welcome aboard Ben

the swing arm needs a shim on each side to keep the swing arm from grinding into the frame. I have no idea what tolerance is needed just not tight and not allowing for any side to side movement once installed. It doesn;t matter what size nipple you use just put it somewhere easy to get to and so it ...

The super relaxed geometry of all the bevel drives is very couch like. raising the forks (dropping the triple clamps - same thing) will change geometry slightly which will give a bit quicker handling. Doing this as well as adding a qtr or 3/8" length of your shocks coupled with the CORRECT size...

please do NOT part out that SS..... Get it together and pass it on to someone who will restore and ride it please.....

Call http://www.enginedynamics.com/ in petaluma CA