<-=- Club Bevel Heaven -=->

I have taken out the hole for the seal to 90mm from 85mm. I want to put in a modern Ducati cluthbasket and hopefully straightcutgears from Veetwo. The Mille seal is 85 mm and the modern Ducatis are 95mm outer diameter. The original Mille seal is 85X65X10mm Viton r23 There are seals that are 90x75x10...

10 dollars to Australia.

Does anyone know the dimensions of this spacer?
Partnr 28.

https://www.ducaticlassics.com/parts/10 ... and-clutch

Or if you know where I can buy them.

Best regards


Hedton

I found 3 in my Garage so just give my your adress and I will send one.

Be careful when you dismantle the dash, use a heatgun and press lightly.
Glue the glass with som good loctiteglue.
Take a photo from the inside so you get all the colours in the correct order.

Best regards

Hedton

Use loctite instead.

I still have some glasses.

Where are you?
60 US dollars plus postage.

I've just moved my parts, so Ill have to take a look where they are.

I accept Paypal and Wiretransfer

Best regards

Hedton

This part https://www.ducaticlassics.com/parts/1000-mille-mhr-and-s2/all/mille-frame-mudguards PartNR: 21 is hard to find. But i found a guy in Australia that makes nice ones in glassfibre............. https://www.instagram.com/p/CJf47pah_y0/ Hope to have it for the upcoming season here in Sweden.

I've mounted a rubber from a modern Ducati on the clutchrod, on my Ducati Mille. Seems to be a good idea to keep the rod clean. You can see the rubber here.............https://www.ducati.ms/threads/clutch-slave-rubber-boot-gaiter.739181/#post-7179098The rubbers can be bought from any ducati dealer. ...

For Lafranconi ........
https://www.ducativintagestore.com/l_h_ ... ilencers_1

For conti........
https://www.ducativintagestore.com/l_h_ ... cati_900_1

The ends seems to be different.

I have made a new brakerod in stainless,that goes into the Rear master cylinder (Brembo PS12) PART NR 066441300, NR 20 in the link https://www.ducaticlassics.com/parts/1000-mille-mhr-and-s2/all/mille-rear-brake-system Gängdjup means threaddepth and Borrdjup means drilldepth, in swedish. A friend of ...

Here is a drawing

The new link to the willyg is now.......

https://willyg.ddns.net/Bevel_Timing/timing.html